Filter
Top Products
Chapter 2 Avaya C460 CLI Commands
138 Avaya C460 Reference Guide
set trunk
User level: read-write, admin.
Use the set trunk command to configure the VLAN tagging mode of a port.
set trunk <module/port> [value]
Example:
set vlan
User level: read-write, admin.
Use the set vlan command to configure VLANs.
The syntax for this command is:
set vlan <vlan-id> [name <vlan-name>]
Example:
module Number of the module (3-6).
port Number of the port on the module. If you do not specify a
number, the vlan tagging mode is set for all the ports on the
module.
You can also specify a range of ports separated by a dash,
for example, 4/5-13 for ports 5 to 13 on module 4.
value • off – forces the port to become a non-tagging port and
persuade the neighboring port to become a non-tagging
port. The port becomes a non-tagging port even if the
neighbor port does not agree to become a non-tagging
port.
• dot1q – specifies an IEEE 802.1Q tagging on a Fast
Ethernet or Gigabit Ethernet port.
C460-1# set trunk 3/3 dot1q
Dot1Q VLAN tagging set on port 3/3.
vlan-id vlan number
vlan-name vlan name
C460-1# set vlan 3 name gregory
VLAN id 3, vlan-name gregory created.