Filter
Top Products
Chapter 2 Avaya C460 CLI Commands
188 Avaya C460 Reference Guide
show port auto-negotiation-flowcontrol-advertisement
User level: read-write, admin.
Use the show port auto-negotiation-flowcontrol-advertisement
command to display the flowcontrol advertisement for a Gigabit port used to
perform auto-negotiation.
The syntax for this command is:
set auto-negotiation-flowcontrol-advertisement [module/port]
[mode]
Example:
show port channel
User level: read-only, read-write, admin.
Use the show port channel command to display Link Aggregation Group
(LAG) information for a specific switch or port.
The syntax for this command is:
show port channel [<module>[/<port>]] [info]
module
(Optional)
Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
port
(Optional)
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
mode no-flowcontrol, asym-tx-only, sym-only or sym-and-asym-rx
C460-1> show port auto-negotiation-flowcontrol-
advertisement 4/49
Port 4/49 pause capabilities was set
module
(Optional)
Number of the module (3-6). If you do not specify a number,
the modules on all the switch are shown.
port
(Optional)
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.