Filter
Top Products
DCS-200 • User’s Guide 133
_K==oÉãçíÉ=`çåíêçä
DCS-200 Command List
System Commands
AUTOCFG
Auto Input Configuration Mode 151
AUTOSAVE
Auto Input Settings Save 151
AUTOTAKE
Auto Take Mode 151
BLKTRAN
Set whether going to black is a direct cut or setup for a take 151
CONTEXT
Set menu context 151
DIAG
Perform a system diagnostic test 152
DIAGD
Display the results of the last performed system diagnostic test 152
ISTAT
Query only command for the input status type and format. 152
LCLR
Clear the selected log (ram copy, not flash) 152
LDMP
Display the current log messages 152
LFEN
Set the mode for the selected log 153
LINT
Set the time interval for writing the enabled logs to flash 153
LOCKOUT
Control the lockout mode of the front panel 153
OSTAT
Query only command for the output status type and format 153
PREVIEW
Query only command for the input, key and black button status on preview 153
PROGRAM
Query only command for the input, key and black button status on program 154
RESET
Reset unit 154
SAVE
System Save 154
SERIAL
Sets the serial port 154
TEMP
Query only command for the temperature of the unit 155
TRNTIME
Set transition time 155
VER
Display Version info 155
VFDBRT
Set VFD brightness 155
Key Commands
LKEY
Luminance Key definition 155
LOGO Commands
LOGODEL
Delete the selected logo file 156
LOGOSAVE
Save the image on Program to the selected logo fame store and file 157
LOGOSEL
Logo selection 157
LOGOSTAT
The logo format status. This command is a query only. 157
Table B-3. DCS-200 Remote Commands (Continued)
Command Description Page