Filter
Top Products
86 DCS-200 • User’s Guide
4. Operation
Using Inputs
råÇÉêëí~åÇáåÖ=^ìíç=^ÅèìáêÉ
Please note the following important points regarding the In Auto Acquire mode:
• If In Auto Acquire is ON and a valid input is selected that does not have a saved
Input Config File associated with it, the system attempts to acquire the source
and save an Input Config file. This process may take a few moments.
• If an input is selected that does have a saved Input Config File associated with it,
the (blinking) source will transition to program after TAKE is pressed.
• When the system performs an Auto Acquire for Inputs 7 or 8, the DCS-200 first
checks for a DVI signal. If not found, the system looks for a valid analog signal.
• If In Auto Acquire is OFF and a valid input is selected (either with or without a
saved Input Config file), the system compares the library file to the input’s
incoming timing.
~ If the timings match, the system transitions to the input after TAKE is
pressed.
~ If the timings do not match, the “Invalid Signal” message appears, and
the system transitions to black after TAKE is pressed.
rëáåÖ=ea`m
With DCS-200, the HDCP mode is essentially automatic. Provided that you connect an
HDCP compliant monitor, you can select and switch between unprotected sources and
“protected” HDCP sources (e.g., a Blu-Ray player) without restriction.
• Inputs 1 - 6 (analog) are unprotected sources.
• Inputs 7 and 8 (analog) are unprotected sources.
• Inputs 7 and 8 (digital) are protected when an HDCP source is connected.
Please note the following important points regarding HDCP operations:
• When the input signal is an HDCP source on DVI inputs 7 or 8, the following
message appears if a non HDCP-compliant monitor is connected:
Figure 4-61. Error Message: HDCP Not Supported
Note
The Input Config file will only be saved if the "Auto Input
Save" mode is ON in the User Preference Menu.
Note
As a prerequisite, ensure that you have read the “A Word
About HDCP” section in Chapter 1 on page 17 prior to
reading this section.
Selection Not Allowed
Output Display does
not support HDCP