Filter
Top Products
DCS-200 • User’s Guide 31
3. Installation
Signal Installation
páÖå~ä=fåëí~ää~íáçå
The figure below illustrates a sample DCS-200 system. Use this figure for reference during
the signal installation process.
Figure 3-2. DCS-200 System Diagram (sample)
Use the following steps to install signals to/from the DCS-200:
1. Input connections — any combination of inputs can be connected.
a. As required, connect analog RGBHV sources to Inputs 1 through 6.
Refer to the “Format Connection Table” section on page 32 for a table
of analog input combinations.
b. As required, connect DVI sources to Inputs 7 and 8 (using the
connector’s digital pins).
c. As required, connect analog sources to Inputs 7 and 8 (using the
connector’s analog pins). A customer-supplied breakout cable or DVI to
HD-15 adapter is required for this connection.
d. As required, connect an HD-SDI or SD-SDI source to Input 9.
2. Output connections — up to three outputs can be connected:
a. If you are connecting the DCS-200 to a digital projector (for example) or
other target device, connect the DVI Output to the projector’s DVI input.
b. If you are connecting the DCS-200 to an analog projector (for example)
or other target device, connect the Analog (HD-15) Output to the
projector’s analog input.
c. If you are connecting the DCS-200 to a Preview monitor, connect the
Preview DVI or Analog (HD-15) Output to the monitor.
DCS-200
Inputs 1 - 6 (Analog)
Inputs 7 - 8 (DVI)
Input 9 (HD/SD SDI)
Sample Source Input
Devices
DVI
Analog
Program
Program
Ethernet
Serial
Preview