Filter
Top Products
3. Connections
3. CONNECTIONS
Overview
• Power connection
• Switching on
• Switching to standby.
• Switching off
• Input Source connection
• Communication connections
• Audio connections
3.1 Power connection
AC Power cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power con nector into the m ale connector
at the front of the projector. The power input is auto-ranging from 90 to 240 VAC.
Fuses
For continued protection against fire hazard :
• refer r eplacement to q ualified service personnel.
• ask to replace with the same type of fuse (T10 AH/250V).
3.2 Switching on
Howtoswitchon.
1. Press the power switch to switch on the projector.
- When ’0’ is visible, the projector is switched off.
- When ’1’ is visible, the projector is switched on
The projector starts in standby mode. The projector indication lamp is red.
Starting image projection.
1. Press Stand by key once on the local keypad or on the remote control.
The projector mode indication lamp will be green (image 4-2, image 4-3)
Image 3-1
R5976182 BARCOREALITY 6500 30012001 17