Filter
Top Products
9. Service mode
9. SERVICE MODE
9.1 Build-up
Build-up
The service menu is build-up in two parts which are connected together with the ’m ore’ item. If the desired item is not in the list of
the displayed menu, s elect ’more’ with the cursor key and push ENTER to display the other items in the service menu.
9.2 Start up
Start up
1. Push the cursor key ↑ or ↓ to highlight Service. (menu 9-1)
2. Press ENTER to display the service mode menu. (m enu 9-2)
ADJUSTMENT MODE
Select a path from below :
AUTO IMAGE
RANDOM ACCESS
INSTALLATION
SERVICE
Source 01
Select with
↑
or
↓
then <ENTER>
<EXIT> to return.
Menu 9 -1
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
LAMP DIMMING
MORE...
Select with
↑
or
↓
then <ENTER>
<EXIT> to return.
Menu 9 -2
SERVICE
BARCO LOGO
PANEL ADJUSTMENTS
UNIFORMITY
RESET INPUT BALANCE
I2C DIAGNOSIS
Select with
↑
or
↓
then <ENTER>
<EXIT> to return.
Menu 9-3
Some items in the Service mode are password protected (when the password function is active). E nter the
password to continue. All other passw ord protected items are n ow available if yo u stay in the adjustm ent
mode.
9.3 Identification
What can be seen on the identification screen?
The identification screen shows the general information of the projector.
The following items will be displayed:
• Type of projector: BARCOREALITY SIM6
• Software version
• Network module: yes
• Proj. address: To change the address of the projector, see B ox content, pa ge 5
• Installation:
- front/ceiling
- front/table
- rear/ceiling
- rear/table
• Baud rate: transfer speed for com mun ication w ith an IBM PC (or compatible) or MAC. The baud rate of the projector mus t be
the same as the baud rate of the connected c omputer. When there is a difference, consult ’Change Baudrate PC’ in this chapter.
• Projector Run Time: gives the total r un time since the first start up. All projectors leave the factory with a run time of approxi-
mately 24 hours.
• Projector Serial number: indicates the fabrication number of the projector. This number can be useful w hen calling for technical
assistance.
R5976182 BARCOREALITY 6500 30012001
77