Filter
Top Products
8. Installation mode
Set up the network configuration
To set up the network configuration, follow the next procedure
1. Push the cursor key ↑ or ↓ to highlight Network Configuration. ( menu 8-22)
2. Press ENTER to display the network configuration menu. (menu 8-23)
3. Set DHCP on or off (contact your n etwork respons ible for t he c orrect setting in your env ironement).
DHCP on DHCP server assigned an IP address to the c lient (network projector).
DHCP off the c lient has to fill out the IP address, the s ubnet mask and the default gateway.
INSTALLATION
INPUT SLOTS
NO SIGNAL
LENS
TEXT BOX POSITION
QUICK ACCESS KEYS
START UP MODE
NETWORK CONFIGURATION
more ...
Select with
↑
or
↓
then <ENTER>
<EXIT> to return.
Menu 8-22
Network configuration
DHCP: ON
IP ADDRESS: 159.150.160.200
SUBNET MASK: 158.150.160.201
DEFAULT GATEWAY:
158.150.300.300
APPLY
Select with
↑
or
↓
<ENTER> to edit
Reprogram with
↑
or
↓
or numeric keys
Apply to confirm
<EXIT> to return.
Menu 8-23
Entering the necessary addresses
1. Select the IP address with the c ursor keys. (menu 8-24)
2. Enter or reprogramm the address with the numeric keys (contact your network responsible for the correct address).
Note: An address contains 4 octets with a maximum value of 255, separated by a bullet.
3. Repeat the above steps for the subnet mask and the gateway.
4. Select APPLY and press ENTER to install the entered addresses .
If a wrong value for an octet is entered, the following error m essage will be disp layed to indicate where the error is located.
Example of message : "Invalid octet in field Su bnet m ask, M axim um value is 255 for each octet ! " (menu 8-25)
Network configuration
DHCP: ON
IP ADDRESS: 159.150.160.200
SUBNET MASK: 158.150.160.201
DEFAULT GATEWAY:
158.150.300.300
APPLY
Select with
↑
or
↓
<ENTER> to edit
Reprogram with
↑
or
↓
or numeric keys
Apply to confirm
<EXIT> to return.
Menu 8-24
NETWORK CONFIGURATION
INVALID OCTED IN
FIELD
SUBNET MASK
MAXIMUM VALUE IS
255 FOR EACH OCTET !
<ENTER> to continue
Menu 8-25
8.10 800 peripheral
The following thinks can be installed for a 800 peripheral:
• Defining the Output module of the RCVDS05
• Defining the Infrared Communication protocol
8.10.1 Defining the Output module of the RCVDS05
Which module are available?
When a RCVDS05 is connected to the projector, the type of output module of this R CVDS 05 has to be defined in the 800 peripheral
menu.
• standard output module
• 5 cable output module
72
R5976182 BARCOREA LITY 6500 30012001