Barco R9004470 Projector User Manual


 
1. Safety
On servicing
Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage potentials
and risk of electric shock.
Refer all servicing to qualied service personnel.
Fence off a restricted area of at least 3 meters around the projector using an eye-catching fence and “KEEP OUT” sings. This
to prevent unauthorized persons coming near the projector during servicing.
Unplug this product from the wall outlet and refer servicing to qualied service technicians under the following conditions:
- When the power cord or plug is damaged or frayed.
- If liquid has been spilled into the equipment.
- If the product has been exposed to rain or water.
- If the product does not operate normally when the operating instructions are followed. Adjust only those controls that are
covered by the operating instructions since improper adjustment of the other controls may result in damage and will often
require extensive work by a qualied technician to restore the product to normal operation.
- If the product has been dropped or the cabinet has been damaged.
- If the product exhibits a distinct change in performance, indicating a need for service.
Replacement parts: When replacement parts are required, be sure the service technician has used original Barco replacement
parts or authorized replacement parts which have the same characteristics as the Barco original part. Unauthorized substitu-
tions may result in degraded performance and reliability, re, electric shock or other hazards. Unauthorized substitutions may
void warranty.
Safety check: Upon completion of any service or repairs to this projector, ask the service technician to perform safety checks
to determine that the product is in proper operating condition.
1.3 Important warnings concerning FLM ight cases
Important warnings concerning stacking/transporting FLM rental ight cases
Stack maximum two (2) FLM rental ight cases high. Never higher.
Surface on which ight case is standing must be level to ensure that the total load is evenly spread out among the four wheels.
The surface must also be able to support the load safely.
Before stacking or transporting ight cases, check the wheels and their xation screws for wear or defects.
Before stacking or transporting ight cases, check that the four lock handles on each ight case are in good working order and
locked securely.
When stacked, make sure the wheels of the upper ight case are precisely positioned in the stacking dishes of the ight case
below.
•Stackedight cases may not be moved. Before stacking, the lower ight case must already be in its nal resting position before
placing the second upon it.
Never stack loaded ight cases in a truck or other transport medium
, unless each ight case is rigidly strapped tight.
In the event of a wheel breaking, ight cases must be rigidly strapped tight to prevent a stack collapsing.
Use an appropriate forklift to raise ight cases and take the necessary precautions to avoid personnel injury.
8
R59770017 FLM HD14 15/03/2010