Barco R98500400 Projector Accessories User Manual


 
Chapter 8 Control Software/Software Monitoring
Daylight Display Systems 114 BARCO DLite Software
8.3.Hot Swap Detection
Introduction
While a DLite Display is connected to a computer, it is possible to check whether a tile is hot swapped or
whether a tile is not responding/missing. The DLite Software automatically detects whether a tile is missing or
replaced from its original configuration.
A TILE IS REPLACED
When a Tile is replaced, the DLite software detects this and forces the new tile to the expected address from
the original configuration. The new tile also is reconfigured: its position and contrast are automatically
adjusted. When selected, the tile is also calibrated to match the entire DLite Display.
For the tile to have the same calibration for the whole display, select the pitch and color temperature to match
that of the entire DLite Display.
A TILE IS MISSING
When a tile is missing for the software (not responding or actually being replace), the software automatically
tries to reconfigure the DLite Display. This could result in a shift of addresses. When a tile is actually missing,
this is represented in the DLite Display Visualization as shown next. The software keeps the same
configuration for the remaining tiles, so nothing is visually different for the client.