Barco R98500400 Projector Accessories User Manual


 
Daylight Display Systems 125 BARCO DLite Software
Chapter 9
Trouble shooting
General
THERE IS NO PICTURE ON THE WALL AND THE DIGITIZER IS NOT
OPERATIONAL
 Check Check the power on the digitizer
 Make sure the digitizer isnt in stand-by mode
THERE IS NO PICTURE ON THE WALL AND THE DIGITIZER IS FULLY
OPERATIONAL
 Check the main power of the wall (every single fuse)
 Check the power entering the modules (min 190 V)
 Check the selected video source and its connections to the digitizer
 Check the cable between the digitizer and the first module
 Bridge the fist module (data cable), and Check again
 Check the contrast of the wall
 Check the scaling of the active video
 Check the fiberlink power status. In the DLite Soft Fiberlink Window you are able to shut down the power to
the fiberlink transmitter resulting in an empty-picture wall.
 Check the content source (black ??)
THERE IS NO COMMUNICATION BETWEEN THE PC AND THE MODULES /
DIGITIZER
 Check the power on the wall and digitizer
 Check whether the DLite control soft is set on-line (bottom right square in the DLite main window should be
colored green)
 Check the communication setup of the software (communication port / baud rate)
 In case of a portable PC Check whether the serial com port is in fact switched on, and not used by another
resident program
 Check the RS232 cable (max 30 m long) itself and whether it is plugged in right on both sides