Filter
Top Products
Chapter 5 Control Software/System Control
Daylight Display Systems 52 BARCO DLite Software
5.7.Database
(click the DATABASE-icon)
All procedures only influence the data stored in the files and not the data of the related tiles, except for the INIT
TILE> TARGET TILES-button and the FILES> TARGET TILES-button in the DATABASE MANAGEMENT-
window.
Access to the database of the DLite Display. This database contains all the individual correction data of all the
tiles of the DLite Display, and can be created during Setup. The information of each tile is stored in a separate
file and linked to its serial number.
1.CURRENT TILES
All the current tiles of the DLite Display, their serial number and their address.
INITIAL TILE>
Choose one tile to be the initial tile. The initial tile can be used to make adjustments on only one tile until
satisfaction with the result. Adjust all other (target) tiles with the same values as this initial tile, this by use of
the INIT TILE> TARGET TILES-button.
To select a tile as init tile act as follows:
1.Click the desired tile in the CURRENT TILES-window
2.Click the INIT TILE-button.
2.TARGET TILES
These are the tiles on which adjustments will be made. To add a tile to the target tiles do the following:
1. Click the desired tile in the CURRENT TILES-window
2. Click the ADD-button
And for removing a tile from the target tiles:
1. Click the desired tile in the TARGET TILES-window
2. Click the DEL-button