Filter
Top Products
Note! The adaptive mode must be configured on the slave device. If the manual mode is
configured on the master device, the line rate will be set according to the fix parameter of
the master device. If the automatic mode is configured on the master device, the line rate
will depend on the DSL line quality.
8.2.13.7 Status command
The status command displays the actual SHDSL connection status.
> shdsl> status
Config :
terminal – coe
Rate Mode – adaptive
Line Rate Range – MAX:2320 MIN:72
Status :
F/W Version : R1.2
Line Code : PAM(SHDSL)
SHDSL Standard: ANNEX B
Last Failed : No failure
Start Progress: PRE ACTIVATION
Attenuation : -NaNdB
Line Quality : InfinitydB
Avg Quality : InfinitydB
Receiver Gain : -InfinitydB
XMIT Power : 0.0dBm
Framer Status : Unknown(0x88)
Current Rate : 0
Line Status : Handshake
> shdsl>
Command format: status
Definitions:
Config: The device configuration
Terminal: The device type (Coe/CPe).
Rate Mode: Line rate mode (Manual/Automatic).
Line Rate Range: Line range rate in the automatic mode.
Status: shdsl status.
Version: 1.0 Page. 61 of 95