Filter
Top Products
Note! The setqos command changes the PVC parameters, first configured by the quick
command (see 8.2.9) or the setwanip command (see 8.3.3.4). If the mentioned PVC is not
found, the system displays an error message.
8.3.3.3 Setrip command
The setrip command sets the RIP type for the used PVC.
> ipoa> setrip 8/35 1
> ipoa>
Command format: setrip [<vpi>/]<vci> <1|2|1&2|0>
Parameter:
VPI/VCI: Sets PVC with the VPI/VCI number.
1: Sets RIP1.
2: Sets RIP2.
1&2: Sets RIP1 и 2.
0: RIP is not used
Note! The setrip command changes the PVC parameters, first configured by the quick
command (see 8.2.9) or the setwanip command (see 8.3.3.4). If the mentioned PVC is not
found, the system displays an error message.
8.3.3.4 Setwanip command
The setwanip command sets the IP address of the SHDSL (WAN) interface and the gateway of
the selected PVC.
> ipoa> setwanip 8/35 216.71.89.12 216.71.89.3
> ipoa>
Command format: setwanip [<vpi>/]<vci> <wanip[/<masknum>]> <gatewayip>
Parameter:
VPI/VCI: Sets PVC with the VPI/VCI number.
Wanip: Sets the IP address of the device WAN interface.
Musknum: Sets the mask number.
Gatewayip: Sets the gateway IP address.
Version: 1.0 Page. 65 of 95