Filter
Top Products
USER’S GUIDE
4–18
Operation Example: Selecting the Parallel Interface
To manually select the parallel interface:
1. Press the
Sel
button to take the printer off-line.
2. Press the
Mode
button and then press the
Set
Button.
When you enter the interface mode, the display first shows the
current interface with the asterisk.
3. Press the
▲
or
▼
button until the interface you want appears on
the display.
Display Message Interface Mode
I/F=PARALLEL
Parallel interface
I/F=RS-232C
Serial interface
I/F=EXTEND I/O
Extended I/O interface
I/F=AUTO
Auto interface selection
✒
Note
• The Extended I/O interface is available only when a commercial MIO
compatible sharing/network card has been installed.
• Some models are supplied with the network card pre-installed.
4. Press the
Set
button to save your selection.
An asterisk appears at the end of the display for a short time.
Then the printer automatically exits from the setting menu to
the interface menu.
5. Press the
▲
or
▼
button until the exit menu appears on the
display.
6. Press the
Set
button.
The printer then automatically returns to the off-line ready
state.