Filter
Top Products
CHAPTER 5 TROUBLESHOOTING
3. Motor/Feed Test
This mode checks the operation of the
feed motor and main motor, and checks the
actual document feed operation.
The corresponding part of the screen
and list of items is shown below.
Figure 5-230
Message Options
Speed Stop/Start
X Res 100/200/300/400/600 (dpi)
Y Res 100/200/300/400/600 (dpi)
Color Gray/Color
Jpeg Normal/HighQuality
Dir
Forward
Note: Initial values are underlined.
Table 5-203
Operation Procedure
1) After selecting the operating conditions
for the target motor, select [Start] to
rotate the motor. Select [Stop] to stop the
motor.
Note: The combination of X (horizontal) and
Y (vertical) resolution should be a
combination that actually exist in the
driver. Otherwise, it will not operate
correctly.
2) After setting the motor operation
conditions and placing the appropriate
paper, select [Feed Test] to start feeding.
Select [Feed Test] again to stop the
motor.
Note: For the feed test, you should set the
feed motor and main motor operation
conditions the same. Otherwise, it will
not operate correctly.
5-18
COPYRIGHT
©
CANON ELECTRONICS INC. 2011 CANON DR-M140 FIRST EDITION