Filter
Top Products
CHAPTER 3 DISASSEMBLY & REASSEMBLY
4. Registration Roller (Drive) Notes on assembling
Before assembling the motor, you
should assemble the 2 retard roller drive
units
{
1
as shown in the figure below.
1) Remove the feed motor (with belt).
(Page 3-6)
2) Unhook the fitting part at the edge of the
gear
{
1
, then remove the gear. Remove
the stopper ring
{
2
and shaft
{
3
.
Figure 3-213
Figure 3-214
Next, align the holes in the motor
mounting plate with the shaft of the
retard roller drive unit and the
positioning pins in the base, and
assemble the motor while letting out the
stopper gear. The edge of the grounding
plate should touch the bottom side of the
mounting plate.
3) Unhook the fitting part
{
1
and remove
the shaft
{
2
. Remove the light guide
{
3
.
Next, unhook the 2 pairs of fitting parts
{
4
and then rotate the float unit
{
5
slightly and remove from the 2 pairs of
fitting parts
{
6
. The link shaft
{
7
also
comes loose at the same time.
Figure 3-215
COPYRIGHT
©
CANON ELECTRONICS INC. 2011 CANON DR-M140 FIRST EDITION
3-7