Filter
Top Products
19-10
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D213 Provision the Card Mode for ML-Series Ethernet Cards
DLP-D213 Provision the Card Mode for ML-Series Ethernet Cards
Step 1 In node view, double-click the ML-Series Ethernet card graphic to open the card.
Step 2 Click the Provisioning > Card tabs.
Step 3 For the ML-Series Ethernet card, select an option from the drop-down Mode menu:
• HDLC—High-level data link control. (Does not support VLAN trunking, which is standard on most
Cisco data devices.)
• GFP-F—Frame-mapped generic framing procedure, a PDU-oriented adaptation mode that maps a
client frame into one GFP frame.
• RPR 802.17—802.17 Resilient Packet Ring, which is IEEE compliant
Note For more details about the interoperabilty of Optical Networking System (ONS) Ethernet
cards, refer to the Ethernet Card Software Feature and Configuration Guide for the
Cisco ONS 15454, Cisco ONS 15454 SDH, and Cisco ONS 15327.
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
DLP-D214 Change the Service State for a Port
Note To provision E-Series or G-Series Ethernet ports, see the “DLP-D220 Provision E-Series Ethernet Ports”
task on page 19-19 or the “DLP-D222 Provision G-Series Ethernet Ports” task on page 19-22.
Step 1 In node view on the shelf graphic, double-click the card with the ports you want to put in or out of
service. The card view appears.
Purpose This task provisions the card mode for ML-Series Ethernet cards
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task puts a port in service or removes a port from service.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher