Filter
Top Products
19-19
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D219 Provision a Low-Order Tunnel Route
DLP-D219 Provision a Low-Order Tunnel Route
Step 1 In the Circuit Creation wizard in the Route Review and Edit area, click the source node icon if it is not
already selected. Arrows indicate the available spans for routing the tunnel from the source node.
Step 2 Click the arrow of the span that you want the low-order tunnel to travel. The arrow turns white. In the
Selected Span area, the From and To fields show the slot and port that will carry the tunnel. The source
VC4 appears.
Step 3 If you want to change the source VC4, change it in the Source VC4 field; otherwise, continue with
Step 4.
Step 4 Click Add Span. The span is added to the Included Spans list and the span arrow turns blue.
Step 5 Repeat Steps 3 and 4 until the tunnel is provisioned from the source to the destination node through all
intermediary nodes.
Step 6 Return to your originating procedure (NTP).
DLP-D220 Provision E-Series Ethernet Ports
Step 1 In node view, double-click the Ethernet card that you want to provision.
Step 2 Click the Provisioning > Port tabs.
Step 3 For each Ethernet port, provision the following parameters:
• Port Name—If you want to label the port, type a port name.
• Mode—Choose the appropriate mode for the Ethernet port:
–
Valid choices for the E100T-G card are Auto, 10 Half, 10 Full, 100 Half, or 100 Full.
–
Valid choices for the E1000-2-G card are 1000 Full or Auto.
Purpose This task provisions the route for a manually routed low-order tunnel.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
You must have the Route Review and Edit page of the Circuit Creation
wizard open.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task enables Ethernet ports for the E-Series cards.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Provisioning or higher