Filter
Top Products
19-54
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D249 Provision IP Settings
Step 2 Click the Provisioning > Network > General tabs.
Step 3 Complete the following information in the fields listed:
• IP Address—Type the IP address assigned to the ONS 15454 SDH node.
Note If TCC2P cards are installed, secure mode is available. When secure mode is off (sometimes
called repeater mode), the IP address entered in the IP Address field applies to the TCC2P
RJ-45 TCP/IP (LAN) port. When secure mode is on, the IP Address field shows the address
assigned to the MIC-C/T/P LAN port, and the Superuser can enable or disable display of the
MIC-C/T/P IP address. See the “DLP-D84 Enable Node Secure Mode” task on page 17-77
as needed. Refer to the “Management Network Connectivity” chapter in the
Cisco ONS 15454 SDH Reference Manual for more information about secure mode.
• Suppress CTC IP Display—Select this check box if you want to prevent the node IP address from
being displayed in CTC to users with Provisioner, Maintenance, or Retrieve security levels. (The IP
address suppression is not applied to users with Superuser security level.)
• LCD IP Display—Choose one of the following:
–
Allow Configuration—(Default) Displays the node IP on the front panel LCD and allows it to
be changed using the ONS 15454 SDH LCD. This option enables the “DLP-D64 Set the IP
Address, Default Router, and Network Mask Using the LCD” task on page 17-53.
–
Display Only—Displays the node IP address on the front panel LCD but does not allow it to be
changed.
–
Suppress Display—Suppresses the node IP address display on the front panel LCD.
• Default Router—If the ONS 15454 SDH is connected to a LAN, enter the IP address of the default
router. The default router forwards packets to network devices that the ONS 15454 SDH cannot
directly access. This field is ignored if any of the following are true:
–
The ONS 15454 SDH is not connected to a LAN.
–
SOCKS proxy server is enabled and the ONS 15454 SDH is provisioned as an end network
element (ENE).
–
Open Shortest Path First (OSPF) is enabled on both the ONS 15454 SDH and the LAN where
the ONS 15454 SDH is connected.
• Forward DHCP Request To—Select this check box to enable DHCP. Also, enter the DHCP server IP
address in the Request To field. The box is unchecked by default. If you will enable any of the
gateway settings to implement the ONS 15454 SDH proxy server features, leave this field blank.
Note If you enable DHCP, computers connected to an ONS 15454 SDH node can obtain
temporary IP addresses from an external DHCP server. The ONS 15454 SDH only forwards
DHCP requests; it does not act as a DHCP server.
• MAC Address—(Display only) Displays the ONS 15454 SDH IEEE 802 MAC address.
Note In secure mode, the Ethernet ports are assigned different MAC addresses, and the
MIC-C/T/P LAN information can be hidden or revealed by a Superuser.