Filter
Top Products
19-63
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D257 View Ethernet Utilization PM Parameters
Step 3 Click the Statistics subtab.
Step 4 Click Refresh. Performance monitoring statistics appear for each port on the card.
Step 5 View the PM parameter names in the Param column. The current PM parameter values appear in the
Port # columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in the
Cisco ONS 15454 SDH Reference Manual.
Note To clear PM counts, see “DLP-D459 Clear Selected PM Counts” task on page 21-37.
Step 6 Return to your originating procedure (NTP).
DLP-D257 View Ethernet Utilization PM Parameters
Step 1 In node view, double-click the E-Series or G-Series Ethernet card where you want to view PM counts.
The card view appears.
Step 2 Click the Performance > Utilization tabs.
Step 3 Click Refresh. Performance monitoring utilization values appear for each port on the card.
Step 4 View the Port # column to find the port you want to monitor.
Step 5 The Tx and Rx bandwidth utilization values for the previous time intervals appear in the Prev-n columns.
For PM parameter definitions, refer to the “Performance Monitoring” chapter in the
Cisco ONS 15454 SDH Reference Manual.
Note To clear PM counts, see the “DLP-D459 Clear Selected PM Counts” task on page 21-37.
Step 6 Return to your originating procedure (NTP).
Purpose This task enables you to view line utilization PM counts on an Ethernet
card and port in order to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher