Filter
Top Products
19-20
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D221 Provision E-Series Ethernet Ports for VLAN Membership
Note Both 1000 Full and Auto modes set the E1000-2-G port to the 1000 Mbps and Full duplex
operating mode; however, flow control is disabled when 1000 Full is selected. Choosing
Auto mode enables the E1000-2-G card to autonegotiate flow control. Flow control is a
mechanism that prevents network congestion by ensuring that transmitting devices do not
overwhelm receiving devices with data. The E1000-2-G port handshakes with the connected
network device to determine if that device supports flow control.
• Enabled—Check this check box to activate the corresponding Ethernet port.
• Priority—Choose a queuing priority for the port. Options range from 0 (Low) to 7 (High). Priority
queuing (IEEE 802.1Q) reduces the impact of network congestion by mapping Ethernet traffic to
different priority levels. Refer to the priority queuing information in the Ethernet Card Software
Feature and Configuration Guide for the Cisco ONS 15454, Cisco ONS 15454 SDH, and
Cisco ONS 15327. This parameter does not apply to an E-Series card in port-mapped mode.
• Stp Enabled—Click this check box to enable Spanning Tree Protocol (STP) on the port. This
parameter does not apply to an E-Series card in port-mapped mode. Refer to the spanning tree
information in the Ethernet Card Software Feature and Configuration Guide for the
Cisco ONS 15454, Cisco ONS 15454 SDH, and Cisco ONS 15327.
Step 4 Click Apply.
Step 5 Repeat Steps 1 through 4 for all other cards in the VLAN or in port-mapped mode.
Step 6 Repeat Steps 1 through 4 for the other card in the point-to-point circuit.
Step 7 Return to your originating procedure (NTP).
DLP-D221 Provision E-Series Ethernet Ports for VLAN Membership
Step 1 In node view, double-click the E-Series card graphic to open the card.
Step 2 Click the Provisioning > VLAN tabs.
Step 3 To put a port in a VLAN, click the port and choose either Tagged or Untag. Table 19-3 describes valid
port settings.
Purpose This task provisions E-Series Ethernet ports for VLAN membership. It
does not apply to E-Series cards in port-mapped mode.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
DLP-D221 Provision E-Series Ethernet Ports for VLAN Membership,
page 19-20
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher