Filter
Top Products
19-75
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D269 Enable Dialog Box Do-Not-Display Option
DLP-D269 Enable Dialog Box Do-Not-Display Option
Note If any user who has rights to perform an operation (for example, creating a circuit) selects the “Do not
show this dialog again” check box on a dialog box, the dialog box is not displayed for any other users
who perform that operation on the network from the same computer unless the command is overridden
using the following task. (The preference is stored on the CTC computer, not in the node database.)
Step 1 From the Edit menu, choose Preferences.
Step 2 In the Preferences dialog box, click the General tab.
The Preferences Management area lists all dialog boxes where “Do not show this dialog again” is
enabled.
Step 3 Choose one of the following options, or uncheck the individual dialog boxes that you want to appear:
• Don’t Show Any—Hides all do-not-display check boxes.
• Show All—Overrides do-not-display check box selections and displays all dialog boxes.
Step 4 Click OK.
Step 5 Return to your originating procedure (NTP).
DLP-D271 Change Node Security Policy on a Single Node
Step 1 In node view, click the Provisioning > Security > Policy tabs.
Purpose This task enables a user-selected do-not-display dialog box preference for
subsequent sessions. It can also be used to disable the do-not-display
option.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task changes the security policy for a single node, including idle user
timeouts, user lockouts, password changes, and concurrent login policies.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser