Filter
Top Products
19-59
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D251 Set Up or Change Routing Information Protocol
• Retransmit Int (sec)—Sets the time that will elapse before a packet is resent. Five seconds is the
default.
• Dead Int (sec)—Sets the number of seconds that will pass while an OSPF router’s packets are
not visible before its neighbors declare the router down. Forty seconds is the default.
c. Click OK.
Step 8 After entering ONS 15454 SDH OSPF area data, click Apply.
If you changed the Area ID, the TCC2/TCC2P cards reset, one at a time. The reset takes approximately
10 to 15 minutes. Table 19-4 on page 19-56 shows the LED behavior during the TCC2/TCC2P reset.
Step 9 Return to your originating procedure (NTP).
DLP-D251 Set Up or Change Routing Information Protocol
Step 1 In node view, click the Provisioning > Network > RIP tabs.
Step 2 Check the RIP Active check box if you are activating RIP.
Step 3 Choose either RIP Version 1 or RIP Version 2 from the drop-down list, depending on which version is
supported in your network.
Step 4 Set the RIP metric. The RIP metric can be set to a number between 1 and 15 and represents the number
of hops.
Step 5 By default, RIP is set to No Authentication. If the router that the ONS 15454 SDH is connected to
requires authentication, complete the following steps. If not, continue with Step 6.
a. Click the No Authentication button.
b. In the Edit Authentication Key dialog box, complete the following:
• Type—Choose Simple Password.
• Enter Authentication Key—Enter the password.
• Confirm Authentication Key—Enter the same password to confirm it.
c. Click OK.
The authentication button label changes to Simple Password.
Purpose This task enables Routing Information Protocol (RIP) broadcasting on the
ONS 15454 SDH. Perform this task if you want to include the
ONS 15454 SDH in RIP-enabled networks.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
You need to create a static route to the router adjacent to the
ONS 15454 SDH for the ONS 15454 SDH to communicate its routing
information to non-DCC-connected nodes.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher