Filter
Top Products
19-56
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D249 Provision IP Settings
Step 6 Click OK. The network view appears. The node icon appears in gray, during which time you cannot
access the node.
Step 7 Double-click the node icon when it becomes green. As necessary, complete the “DLP-D65 Create a
Static Route” task on page 17-56 or the “DLP-D250 Set Up or Change Open Shortest Path First
Protocol” task on page 19-57. If you do not need to create a static route or set up OSPF, continue with
the “NTP-D28 Set Up Timing” procedure on page 4-9.
Step 8 Return to your originating procedure (NTP).
Table 19-4 LED Behavior During TCC2/TCC2P Reboot
Reboot Activity Active TCC2/TCC2P LEDs Standby TCC2/TCC2P LEDs
Standby TCC2/TCC2P card updated
with new network information.
Memory test (1 to 2 minutes).
If an AIC or AIC-I card is installed, the
AIC is updated.
The standby TCC2/TCC2P becomes
the active TCC2/TCC2P.
ACT/STBY: Flashing green.
AIC FAIL and alarm LEDs light up briefly.
1. ACT/STBY: Flashing yellow.
2. FAIL LED: Solid red.
3. All LEDs on except ACT/STBY.
4. CRIT turns off.
5. MAJ and MIN turn off.
6. REM, SYNC, and ACO turn off.
7. All LEDs except A&B PWR:
turn off (1 to 2 minutes)
8. ACT/STBY: Solid yellow.
9. Alarm LEDs: Flash once.
10. ACT/STBY: Solid green.
Memory test (1 to 2 minutes).
TCC2/TCC2P updated with new
network information.
TCC2/TCC2P becomes the standby
TCC2/TCC2P.
1. All LEDs: Turn off (1 to 2 minutes).
CTC displays “Lost node connection,
switching to network view” message.
2. FAIL LED: Solid red.
3. FAIL LED: Flashing red.
4. All LEDs on except ACT/STBY.
5. CRIT turns off.
6. MAJ and MIN turn off.
7. REM, SYNC, and ACO turn off; all
LEDs are off.
8. ACT/STBY: Solid yellow.
9. ACT/STBY: Flashing yellow.
10. ACT/STBY: Solid yellow.
ACT/STBY: Solid green