Filter
Top Products
19-45
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D241 Clear an MS-SPRing Manual Ring Switch
Step 1 From node or network view, click the Circuits > Rolls tabs.
Step 2 Click the rolled circuit that you want to cancel.
Step 3 Click Cancel.
Step 4 Return to your originating procedure (NTP).
DLP-D241 Clear an MS-SPRing Manual Ring Switch
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Provisioning > MS-SPRing tabs.
Step 3 Choose the MS-SPRing that the Manual ring switch that you want to clear and click Edit.
Tip To move an icon to a new location, for example, to see MS-SPRing channel (port) information more
clearly, click an icon on the Edit MS-SPRing network graphic and while pressing Ctrl, drag the icon to
a new location.
Step 4 Right-click the MS-SPRing node channel (port) where the Manual ring switch was applied and choose
Set West Protection Operation or Set East Protection Operation, as applicable.
Step 5 In the dialog box, choose CLEAR from the drop-down list. Click OK.
Step 6 Click Yes in the Confirm MS-SPRing Operation dialog box. The letter “M” is removed from the channel
(port) and the span turns green.
Step 7 From the File menu, choose Close.
Step 8 Return to your originating procedure (NTP).
Purpose This task clears a Manual ring switch.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher