Filter
Top Products
19-65
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D260 Set Auto-Refresh Interval for Displayed PM Counts
• 15 min: This option displays the specified PM counts in fifteen-minute time intervals.
• 1 hour: This option displays the specified PM counts in one-hour time intervals.
• 1 day: This option displays the specified PM counts in one-day (24 hours) time intervals.
Step 5 Click Refresh. The PM counts refresh with values based on the selected time interval.
Step 6 Return to your originating procedure (NTP).
DLP-D260 Set Auto-Refresh Interval for Displayed PM Counts
Step 1 In node view, double-click the card where you want to view PM counts. The card view appears.
Step 2 Click the Performance tab.
Step 3 Click the Auto-refresh drop-down list and choose one of the following options:
• None: This option disables the auto-refresh feature.
• 15 Seconds: This option sets the window auto-refresh at 15-second time intervals.
• 30 Seconds: This option sets the window auto-refresh at 30-second time intervals.
• 1 Minute: This option sets the window auto-refresh at 1-minute time intervals.
• 3 Minutes: This option sets the window auto-refresh at 3-minute time intervals.
• 5 Minutes: This option sets the window auto-refresh at 5-minute time intervals.
Step 4 Click Refresh. The PM counts for the newly selected auto-refresh time interval appear.
Depending on the selected auto-refresh interval, the PM counts are automatically updated when each
refresh interval completes. If the auto-refresh interval is set to None, the PM counts that appear are not
updated unless you click Refresh.
Step 5 Return to your originating procedure (NTP).
Purpose This task changes the auto-refresh intervals for updating the displayed
PM counts in a window.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher