Filter
Top Products
19-62
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D256 View Ethernet Statistics PM Parameters
Step 5 Click the Maintenance > Cross-Connect tabs.
Step 6 In the Cross-Connect Cards area, make a note of the active and standby slots.
Step 7 On the shelf graphic, verify that the active cross-connect card shows a green ACT LED and the standby
cross-connect card shows an amber SBY LED. If these conditions are not present, review the
“DLP-D333 Install the XC-VXL-10G, XC-VXL-2.5G, or XC-VXC-10G Cards” task on page 20-25 or
contact your next level of support.
Step 8 Click Switch.
Step 9 In the Confirm Switch dialog box, click Yes.
Step 10 Verify that the active slot noted in Step 6 becomes the standby slot, and that the standby slot becomes
the active slot. The switch should appear within 1 to 2 seconds.
Step 11 Verify that traffic on the test set connected to the node is still running. Some bit errors are normal, but
traffic flow should not be interrupted. If a traffic interruption occurs, do not continue. Refer to your next
level of support.
Note A cross-connect side-switch performed using XC-VXC-10G cards and TCC2/TCC2P cards is
errorless.
Step 12 Wait 60 seconds, then repeat Steps 7 through 9 to return the active/standby slots to their configuration
at the start of the procedure.
Step 13 Verify that the cross-connect cards appear as you noted in Step 6.
Step 14 Return to your originating procedure (NTP).
Note During a maintenance side switch or soft reset of an active XC10G card, the 1+1 protection
group might display a protection switch. To disallow the protection switch from being displayed,
the protection group should be locked at the node where XC switch or soft reset of an active XC
switch is in progress.
DLP-D256 View Ethernet Statistics PM Parameters
Step 1 In node view, double-click the E-Series or G-Series Ethernet card where you want to view PM counts.
The card view appears.
Step 2 Click the Performance tab.
Purpose This task enables you to view current statistical performance monitoring
(PM) counts on an Ethernet card and port in order to detect possible
performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher