Filter
Top Products
19-53
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D248 Delete VLANs
Step 5 Complete the “NTP-D16 Install STM-N Cards and Connectors” procedure on page 2-7.
Step 6 Return to your originating procedure (NTP).
DLP-D248 Delete VLANs
Note VLANs in use will not be deleted.
Step 1 From the View menu, choose Go to Network View.
Step 2 From the Tools menu, choose Manage VLANS.
Step 3 In the All VLANs dialog box, click the VLAN that you want to remove.
Step 4 Click Delete.
Step 5 In the confirmation dialog box, click Yes.
Step 6 Return to your originating procedure (NTP).
DLP-D249 Provision IP Settings
Caution All network changes should be approved by your network (or LAN) administrator.
Step 1 If you are in network view, switch to node view by double-clicking the node you want to turn up on the
network map.
Purpose This task removes VLANs from a domain.
Tools/Equipment None
Prerequisite Procedures See Chapter 6, “Create Circuits and Low-Order Tunnels” for circuit
creation procedures.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task provisions IP settings, which includes the IP address, default
router, Dynamic Host Configuration Protocol (DHCP) access, firewall
access, and proxy server settings for an ONS 15454 SDH node.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed Required
Onsite/Remote Onsite or remote
Security Level Superuser