Filter
Top Products
19-29
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D232 Change Active and Standby Span Color
Step 2 Click the circuit you want to rename, then click Edit.
Step 3 If you want to edit a VCAT circuit member name, complete the following steps in the Edit Circuit
window to access the Edit Member window. If not, continue with the Step 4.
a. Click the Members tab.
b. Click the VCAT member that you want to edit, then click Edit Member. The Edit Member window
appears.
Step 4 In the General tab of the Edit Circuit or Edit Member window, click the Name field and edit or rename
the circuit. Names can contain up to 48 alphanumeric and/or special characters.
Note If you will create a monitor circuit on this circuit, do not make the name longer than
44 characters, because monitor circuits add “_MON” (four characters) to the circuit name.
Step 5 Click Apply.
Step 6 From File menu, choose Close.
Step 7 If you changed the name of a VCAT circuit member, repeat Step 6 for the Edit Circuit window.
Step 8 In the Circuits window, verify that the circuit was correctly renamed.
Step 9 Return to your originating procedure (NTP).
DLP-D232 Change Active and Standby Span Color
Step 1 From the Edit menu in node, network, or card view, choose Preferences.
Step 2 In the Preferences dialog box, click the Circuit tab.
Step 3 Complete one or more of the following steps, as required:
• To change the color of the active (working) span, continue with Step 4.
• To change the color of the standby (protect) span, continue with Step 5.
• To return active and standby spans to their default colors, continue with Step 6.
Step 4 As needed, change the color of the active span:
a. In the Span Colors area, click the colored square that is near the word Active.
b. In the Pick a Color dialog box, click the color for the active span, or click Reset if you want the
active span to display the last applied (saved) color.
Purpose This task changes the color of active (working) and standby (protect)
circuit spans shown on the detailed circuit map of the Edit Circuits
window. By default, working spans are green and protect spans are purple.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher