Filter
Top Products
19-44
Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007
Chapter 19 DLPs D200 to D299
DLP- D239 Delete a Roll
DLP-D239 Delete a Roll
Step 1 From the View menu, choose Go To Network View.
Step 2 Click the Circuits > Rolls tabs.
Step 3 Click the rolled circuit that you want to delete.
Step 4 From the Tools menu, choose Circuits > Delete Rolls.
Step 5 In the confirmation dialog box, click Yes.
Step 6 Return to your originating procedure (NTP).
DLP-D240 Cancel a Roll
Caution If you click cancel while performing a Dual roll in Manual mode and have a valid signal detected on both
rolls, you will see a dialog box stating that this can cause a traffic hit and asking if you want to continue
with the cancellation. Cisco does not recommend cancelling a dual roll when a valid signal has been
detected. To return the circuit to the original state, Cisco recommends completing the roll, then using
bridge and roll again to roll the circuit back.
Purpose This task deletes a roll. Use caution when selecting this option, traffic
might be affected. Delete a roll only if it cannot be completed or cancelled
in normal ways. Circuits might have a PARTIAL status when this option is
selected. See Table 20-31 on page 20-77 for a description of circuit
statuses.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
NTP-D332 Bridge and Roll Traffic, page 7-9
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task cancels a roll. When the roll mode is Manual, you can only cancel
a roll before you click the Complete button. When the roll mode is Auto,
cancel roll is only allowed before a good signal is detected by the node or
before clicking the Force Valid Signal button. A dual or single roll can be
cancelled before the roll state changes to ROLL_COMPLETED.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
NTP-D332 Bridge and Roll Traffic, page 7-9
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher