Filter
Top Products
1-6
Cisco Physical Access Gateway User Guide
OL-20932-02
Chapter 1 Overview
Optional Expansion Modules
Module Features
Figure 1-4 shows the modules for a Cisco Physical Access Control system.
Figure 1-4 Cisco Physical Access Gateway and the Optional Modules
Gateway Cisco Reader Module Cisco Input Module Cisco Output Module
• Mandatory module.
• Connects up to two doors
using the 10 pin Wiegand
reader port, which can be
configured as two
five-pin ports.
• Connects up to 15
optional expansion
modules using a
three-wire CAN bus.
1
• Power-over-Ethernet
(POE) or 12 through 24V
DC
• Two Ethernet ports
• Three output ports:
Form C contacts rated at
5A 30VDC
• Three supervised input
ports
2
• Tamper & Power Fail
inputs (can be configured
as additional
unsupervised inputs)
• One RS-485 serial port
(not supported in this
release).
1. The modules are connected using the CAN1 interface. The CAN2 interface is not supported in this release.
2. A supervised input supports four states: normal, alarm, open and short. An unsupervised input only indicates normal or alarm.
• Requires connection to
an Access Gateway using
a three-wire CAN bus.
• Connects up to two doors
using the 10 pin Wiegand
reader port, which can be
configured as two 5 pin
ports.
• Power: 12 through 24V
DC
• Three output ports: Form
C contacts rated at 5A
30VDC
• Three supervised input
ports
• Tamper & Power Fail
inputs (can be configured
as additional
unsupervised inputs)
• One RS-485 serial port
(not supported in this
release).
• Requires connection to
an Access Gateway using
a three-wire CAN bus.
• 10 supervised input ports
• Example inputs are: Push
button switches, Glass
Break sensors, or any
contact closure input.
circuit
• Power: 12 through 24V
DC
• Tamper & Power Fail
inputs (can be configured
as additional
unsupervised ports)
• Requires connection to
an Access Gateway using
a three-wire CAN bus.
• 8 output ports: Form C
contacts rated at 5A
30VDC
• Example outputs are:
lights, LEDs, or any
contact closure output
circuit.
• Power: 12 through 24V
DC
• Tamper & Power Fail
inputs (can be configured
as additional
unsupervised ports)
Cisco Physical
Access Gateway
Reader
Module
Input
Module
Output
Module
187057