Filter
Top Products
3-9
Cisco Physical Access Gateway User Guide
OL-20932-02
Chapter 3 Connecting a Cisco Reader Module
Installing the Cisco Reader Module
Step 4 Connect one or two door reader devices to the Wiegand interface using one of the following
configurations:
• Connect a single door reader using all 10 Wiegand interface pins.
• Connect one or two door readers using 5-pin Wiegand interface connections (for installations where
a 5-pin interface is sufficient).
Figure 3-8 shows the location of the Wiegand interface connections. The table describes the connections
for 10-pin and 5-pin reader interface connections. The wire connectors from the reader device are shown
in parentheses. If attaching a second reader, use the alternative connections shown in the column on the
far right.
Figure 3-8 Wiegand Interface on the Gateway and Reader Modules
Chassis
Label Description
One Reader
10 Wire Connection
First Reader in a
5 Wire Connection
Second Reader in a
5 Wire Connection
PWR +12v PWR (red)
1
PWR (red) PWR (red)
GND Ground GND (black) GND (black) GND (black)
D0 Data 0 D0 (green) D0 (green) ----------
D1/CLCK Data 1 D1/CLCK (white) D1/CLCK (white) ----------
DRTN Shield DRTN (shield) DRTN (shield) DRTN (shield)
GRN Output
2
GRN (orange) GRN (orange) ----------
271603
10
9
8
7
6
5
4
3
2
1