Filter
Top Products
Configuring Networking
Configuring the WAN Settings
Cisco RV215W Wireless-N VPN Firewall Administration Guide 31
6
STEP 3 Enter this information:
Internet IP Address Enter the IP address of the WAN port.
Subnet mask Enter the subnet mask of the WAN port.
Default Gateway Enter the IP address of the default gateway.
L2TP Server Enter the IP address of the L2TP server.
Username Enter your username assigned to you by the ISP.
Password Enter your password assigned to you by the ISP.
Connect on Demand Select this option if your ISP charges based on the
amount of time that you are connected. When you
select this option, the Internet connection is on only
when traffic is present. If the connection is idle—
that is, no traffic is flowing—the connection is
closed. If you click Connect on Demand, enter the
number of minutes after which the connection
shuts off in the Max Idle Time field.
Keep Alive When you select this option, the Internet
connection is always on. In the redial period field,
enter the number of seconds after which the
device attempts to reconnect if it is disconnected.
Authentication Type Auto-negotiation—The server sends a
configuration request specifying the security
algorithm set on it. The device then sends back
authentication credentials with the security type
sent by the server.
PAP—Password Authentication Protocol (PAP) is
used to connect to the ISP.
CHAP—Challenge Handshake Authentication
Protocol (CHAP) is used to connect to the ISP.
MS-CHAP or MS-CHAPv2—Microsoft Challenge
Handshake Authentication Protocol is used to
connect to the ISP.