Filter
Top Products
Configuring the Firewall
Configuring Access Rules
Cisco RV215W Wireless-N VPN Firewall Administration Guide 91
8
STEP 6 In the End Port field, enter the last TCP or UDP port of the range that the service
uses.
STEP 7 Click Save.
To edit an entry, select the entry and click Edit. Make your changes, then click
Save.
Configuring Access Rules
Configuring the Default Outbound Policy
The Access Rules page allows you to configure the default outbound policy for
the traffic that is directed from the secure network (LAN) to the non-secure
network (dedicated WAN/optional).
The default inbound policy for traffic flowing from the non-secure zone to the
secure zone is always blocked and cannot be changed.
To configure the default outbound policy:
STEP 1 Choose Firewall > Access Rules.
STEP 2 Choose Allow or Deny.
Note: Ensure that IPv6 support is enabled on the device to configure an IPv6
firewall. See Configuring IPv6.
STEP 3 Click Save.
Reordering Access Rules
The order in which access rules are displayed in the access rules table indicates
the order in which the rules are applied. You may want to reorder the table to have
certain rules applied before other rules. For example, you may want to apply a rule
allowing certain types of traffic before blocking other types of traffic.
To reorder access rules:
STEP 1 Choose Firewall > Access Rules.
STEP 2 Click Reorder.