Filter
Top Products
support.dell.com Error Messages A-1
'!
This appendix explains the error message format, error message by firmware module,
and other possible errors.
&-
There are two error message formats for the PowerVault 56F whether you are gather-
ing information from the front panel or using a remote
Te l n e t
session. The front panel
shows an abbreviated message and
Te l n e t
displays the entire error message.
In all cases, the last error encountered is the first error displayed. Up to 64 messages
are held in a buffer. If the 64 message limit is exceeded, the messages are overwrit-
ten in a first in, first out sequence.
.
The
errShow
command displays all detected errors. The output provides additional
information over the front panel display. The following information is displayed in
Figure A-1:
There are two errors which have been detected.
The task ID and task name that incurred the error (task names are displayed
using the
i
command).
The error type, date and time, the error level, and description.
If there is more than one occurrence of an error type, the number of occurrences
is shown in brackets following the error level.
NOTE: The error counter goes to a maximum of 999.
The display halts after each error is displayed, prompting you to either press <Enter>
to continue or type a
Q
to quit. Continue pressing <Enter> until the prompt
<8
is
displayed.