Filter
Top Products
support.dell.com Error Messages A-3
INPORT (2) The input port in the IU received
by the path selection task is out
of range.
Check that all paths and routing tables are
correct. If they are not correct, reboot the
local switch.
MSG (2) The path selection task has
received an unknown message
from another task.
Check that all paths and routing tables are
correct. If they are not, reboot the neigh-
bor switch.
Check the paths and routes again. If they
are still incorrect, reboot the local switch.
REMDOMAIN
(2)
The message received from a
neighbor switch has a source
domain ID out of range.
Check that all paths and routing tables are
correct. If they are not, reboot the neigh-
bor switch.
Check the paths and routes again. If they
are still incorrect, reboot the local switch.
SCN (3) The path selection task has
received a State Change Notifica-
tion message that it does not
recognize.
Check that all paths and routing tables are
correct. If they are not, reboot the local
switch.
VERSION (2) The FSPF protocol version run-
ning on the local switch is lower
than a neighbor’s switch.
Check the protocol version on both
switches using the
fspfShow
command.
If the two versions differ, update the soft-
ware on the local switch.
HLO INVHLO (1) The path selection task has
received a HELLO message with
an invalid parameter from a
neighbor switch.
Check that all paths and routing tables are
correct. If they are not, reboot the neigh-
bor switch.
Check the paths and routes again. If they
are still incorrect, reboot the local switch.
LSDB LSID (2) A Link State Record received as
part of a Link State Update has
an out of range domain ID.
Check that all paths are correct. If any
path is missing to any switch in any part of
the fabric, reboot the switch with the
missing path.
MCAST ADDBRANCH
(2)
A branch is being added to a
broadcast or multicast tree, but
the parameters are incorrect.
If this is caused by a configuration
command, check the parameter values.
Otherwise, check the broadcast tree with
the
bcastShow
command. If the tree is
incorrect, reboot the local switch.
ADDPORT (3) A multicast routing table pro-
gramming failed.
Run the
portLogShow
command. Con-
tact Customer Support.
NOPARENT (2) An error occurred while comput-
ing a broadcast or multicast tree.
Run the
LSDbAllShow
command. Con-
tact Customer Support.
NOPARENTLS
R (2)
An error occurred while comput-
ing a broadcast or multicast tree.
Run the
LSDbAllShow
command. Con-
tact Customer Support.
0+
"
* " )