Filter
Top Products
A-16 Installation and Troubleshooting Guide
DIAG-CMINOCAP
(T!--
[cmiTest]
CMI intended receiver ASIC
failed to get CMI capture flag
ASIC or mainboard
failure
Replace main-
board assembly
DIAG-CMISA1
(T!-!
[cmiTest]
An attempt to send a CMI mes-
sage from ASIC to ASIC failed
ASIC failure Replace main-
board assembly
DIAG-CMNOBUF
(T!
[centralMemoryTest]
Port could not get any buffer ASIC failure Replace main-
board assembly
DIAG-DATA
(T!(5-(
[portLoopbackTest, crossPort-
Te s t ]
Payload received by port did
not match payload transmitted
Mainboard, GBIC
module or fiber
cable failure
Replace main-
board assembly,
GBIC module or
fiber cable
DIAG-ERRSTAT
(T!!75-
-75
- - 7
[portLoopbackTest,
crossPortTest, spinSilk]
Port Error Statistics counter is
nonzero, meaning an error was
detected when receiving
frames.
One of the following status
errors occurred:
Enc_In: Encoding error,
inside frame
CRC_err: Cyclic redun-
dancy check on frame
failed
Tr u nc F r m : Truncated
frame
FrmTooLong: Frame too
long
BadEOF: Bad end of file.
Enc_out: Encoding error,
outside frame
BadOrdSet: Bad symbol
on fiber-optic cable
DiscC3: Discarded Class 3
frames
ASIC, mainboard,
GBIC module or
fiber cable failure
Replace main-
board assembly,
GBIC module or
fiber cable
DIAG-INIT
(T!)5-)5- )
[portLoopbackTest, crossPort-
Test, spinSilk]
Port failed to go active in the
loopback mode requested
ASIC, mainboard,
GBIC module or
fiber cable failure
Replace main-
board assembly,
GBIC module or
fiber cable
DIAG-INTNIL
(T!-
[cmlTest]
ASIC failed to get a CMI error
(interrupt)
ASIC failure Replace main-
board assembly
02+&
& )