Filter
Top Products
116 Removing and Installing Parts
6
Replace the drive panel (see "Replacing the Drive Panel" on page 106).
7
Replace the computer cover (see "Replacing the Computer Cover" on page 127).
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
8
Connect the computer and devices to electrical outlets, and turn them on.
Installing a CD/DVD Drive
1
Follow the procedures in "Before You Begin" on page 75.
2
Remove the computer cover (see "Removing the Computer Cover" on page 76).
3
Remove the drive panel (see "Removing the Drive Panel" on page 105).
4
Remove the existing CD/DVD drive, if applicable (see "Removing a CD/DVD Drive" on page 114).
5
Prepare the CD/DVD drive for installation and check the documentation that accompanied the drive
to verify that the drive is configured for your computer.
NOTE: If you are installing an IDE drive, configure the drive for the cable select setting.
1 drive release latch 2 CD/DVD drive
1
2
book.book Page 116 Friday, October 27, 2006 4:02 PM