Filter
Top Products
Setting Up and Using Your Computer 17
Back I/O Connectors
1 link integrity light
• Green — A good connection exists between a 10-Mbps network and the
computer.
• Orange — A good connection exists between a 100-Mbps network and the
computer.
• Yellow — A good connection exists between a 1000-Mbps (1-Gbps) network and
the computer.
• Off — The computer is not detecting a physical connection to the network.
2 network adapter
connector
NOTICE: Do not plug a telephone cable into the network adapter connector.
Use the network adapter connector to attach your computer to a network or
broadband device. Connect one end of a network cable to either a network jack or
your network or broadband device, and then connect the other end of the network
cable to the network adapter connector on your computer. A click indicates that
the network cable has been securely attached.
On computers with an additional network connector card, use the connectors on
the card and on the back of the computer when setting up multiple network
connections (such as a separate intra- and extranet).
NOTE: It is recommended that you use Category 5 (or greater) wiring and connectors
for your network. If you must use Category 3 wiring, force the network speed to 10
Mbps to ensure reliable operation.
3 network activity light Flashes a yellow light when the computer is transmitting or receiving network
data. A high volume of network traffic may make this light appear to be in a
steady "on" state.
4 keyboard connector Plug a standard PS/2 keyboard into the purple keyboard connector. Turn off the
computer and any attached devices before you connect a keyboard to the
computer. If you have a USB keyboard, plug it into a USB connector.
5 mouse connector Plug a standard PS/2 mouse into the green mouse connector. Turn off the
computer and any attached devices before you connect a mouse to the computer.
If you have a USB mouse, plug it into a USB connector.
14
1213
15
9
10
11
45 6 7 8
213
book.book Page 17 Friday, October 27, 2006 4:02 PM