Filter
Top Products
96 Removing and Installing Parts
11
Attach the graphics card bridge (if required for your dual-graphics configuration), pressing firmly so
that it completely covers the connector tabs.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug the cable
into the computer.
12
If present, lower the card retention device that lays over the installed cards and snap it into place.
13
Replace the computer cover (see "Replacing the Computer Cover" on page 127), reconnect the
computer and devices to electrical outlets, and then turn them on.
Network Adapter and Sound Card Settings
If you installed a sound card:
1
Enter system setup (see "Entering System Setup" on page 134), select
Integrated Audio Controller
,
and then change the setting to
Off
.
2
Connect external audio devices to the sound card connectors. Do not connect external audio devices
to the microphone, speaker/headphone, or line-in connectors on the back panel.
1 graphics card bridge (not
present on some dual
graphics card configurations)
2 power connectors (2) 3 dual-PCI Express graphics
cards
1
3
2
book.book Page 96 Friday, October 27, 2006 4:02 PM