Filter
Top Products
Removing and Installing Parts 121
Installing the Liquid Cooling Assembly
1
Follow the procedures in "Before You Begin" on page 75.
2
Remove the computer cover (see "Removing the Computer Cover" on page 76).
NOTICE: Ensure that adequate thermal grease is applied to the top of the processor. Thermal grease is critical for
ensuring adequate thermal bonding, which is a requirement for optimal processor operation.
3
Apply thermal grease to the top of the processor, as needed.
4
Align the screw holes on the liquid cooling assembly with the holes on the base of the computer, then
tighten the seven screws to secure the assembly.
5
Connect the fan cable to the FAN1_CPU connector on the system board (see "System Board
Components" on page 79).
6
Connect the liquid cooling assembly cable to the TEC_PUMP connector on the system board (see
"System Board Components" on page 79).
7
Connect the liquid cooling assembly power cable.
1 liquid cooling assembly 2 captive screws (6) 3 screw (loose)
2
1
3
book.book Page 121 Friday, October 27, 2006 4:02 PM