Filter
Top Products
90 Removing and Installing Parts
NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the
computer cover from closing properly or cause damage to the equipment.
NOTICE: An incorrectly attached graphics power cable may result in degraded graphics performance.
9
Connect any cables that should be attached to the card.
See the documentation for the card for information about the card’s cable connections.
NOTICE: Before rotating the card retainer back into place, ensure that the tops of all cards and filler brackets are
flush with the alignment bar and the notch in the top of each card or filler bracket fits around the alignment guide.
10
Rotate the card retainer back into its original position; push its tip so that its tab clicks into place.
11
If present, lower the card retention device that lays over the installed cards and snap it into place.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug the cable
into the computer.
12
Replace the computer cover (see "Replacing the Computer Cover" on page 127), reconnect the
computer and devices to electrical outlets, and then turn them on.
13
Install any drivers required for the card as described in the card documentation.
NOTE: If you installed a sound card or a network adapter, see "Network Adapter and Sound Card Settings" on
page 96.
book.book Page 90 Friday, October 27, 2006 4:02 PM