Filter
Top Products
106 Dell™ Printer Configuration Web Tool
Re-enter Community Name
(Read/Write)
*1
Enter the community name to access (read and write) data again to
confirm.
Community Name (Trap)
*1
Specifies the community name used for trap up to 31
alphanumeric characters.
The original setting will remain valid if nothing is entered.
Characters entered for community name in the previous settings
will not be displayed on the screen. The default Trap Community is
" " (NULL).
Re-enter Community Name
(Trap)
*1
Enter the community name used for trap again to confirm.
Trap Notification 1-4 Trap Address Type Select the trap address type from the list. Selecting Off clears the
settings in Trap Address, Port Number, and Notify, and does not
notify trap occurrence. Selecting IPv4 or IPv6 allows you to enter
Trap Address.
Trap Address Specifies the IP address and IP socket in the following format:
•IPv4
Specifies the IP address and IP socket in the
nnn.nnn.nnn.nnn:mmmmm format. Each section of "nnn" is a
variable value between 0 and 255. Note that values 127 and 224-
254 are not valid for the first three-digits only. The IP socket
mmmmm is a variable value between 0 and 65535.
•IPv6
Specifies the IP address and IP socket in the
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:mmmmm format. Each
section of "xxxx" is a hexadecimal variable value between 0 and
ffff. The IP socket mmmmm is a variable value between 0 and
65535.
Port Number Enter the SNMP trap destination port number.
Notify Specifies whether to notify trap occurrence.
Authenticate Error Trap Specifies whether to notify Authenticate Error Trap.
*
1
The default value can be changed by using Dell Printer Configuration Web Tool.