Filter
Top Products
130 Understanding the Printer Menus
Protocol
Purpose:
To enable or disable each protocol.
The change takes effect after the printer is turned off and then on.
Va lue s :
IP Filter
Purpose:
To block data received from certain IP addresses through the wired or wireless network. You can set up to five IP
addresses. The change takes effect after the printer is turned off and then on.
Va lue s :
NOTE: This item is only available for LPD or Port9100.
Reset LAN
Purpose:
To initialize network data stored in NVM (non-volatile memory). After executing this function and rebooting the
printer, all network settings are reset to their default values.
LPD Enable* Enables the Line Printer Daemon (LPD) port.
Disable Disables the LPD port.
Port9100 Enable* Enables the Port9100 port.
Disable Disables the Port9100 port.
WSD Enable* Enables the Web Services on Devices (WSD) port.
Disable Disables the WSD port.
SNMP UDP Enable* Enables the UDP port.
Disable Disables the UDP port.
E-Mail Alert Enable* Enables the E-mail Alert feature.
Disable Disables the E-mail Alert feature.
EWS Enable* Enables an access to Dell™ Printer Configuration Web Tool embedded in the printer.
Disable Disables an access to Dell Printer Configuration Web Tool embedded in the printer.
Bonjour (mDNS) Enable* Enables the Bonjour (mDNS).
Disable Disables the Bonjour (mDNS).
No. n/Address
(n is 1-5.)
Sets the IP address for Filter
n
.
No. n/Mask
(n is 1-5.)
Sets the address mask for Filter
n
.
No. n/Mode
(n is 1-5.)
Off* Disables the feature for Filter
n
.
Accept Accepts an access from the specified IP address.
Reject Rejects an access from the specified IP address.