Filter
Top Products
78 Operator Panel
Status of Wi-Fi | WPS Button Backlight
This section describes when the backlight of the (Wi-Fi | WPS) button lights up or blinks.
For more information, see "Wireless Problems" on page 224.
*
1
You can enable/disable the Wireless LAN settings. For more information, see "Wireless LAN" on page127.
Wi-Fi | WPS Button
Backlight
Wireless LAN
settings
*1
Printer Status Error Message
Off N/A Connected to the network via Ethernet
cable;
Wi-Fi settings is not available when
an Ethernet cable is connected to the
printer.
-
Disable
--
Enable
The printer enters Sleep/Deep Sleep mode -
On
Enable
Wireless link established -
Blinking
normal
Enable
Searching for wireless LAN access point or
router
-
Blinking
slowly
Enable
Searching/Connecting with WPS access
point or router during wireless operation
-
Blinking
fast
Enable
No wireless LAN access point or router
found within the specified time
Wireless Timeout Error
WPS Connection failure
WirelessDownload Error
Wireless LAN access point or router found
but connection error occurs (Passphrase
error)
Wireless Password Error
Detected WPS signals from multiple access
points or routers during wireless operation
(session overlap)
Wireless Session Overlap
Error
WPS Connection failure; Security setting of
the wireless LAN access point or router is
WEP, which is unsupported on WPS.
Wireless WEP AP Connected
Error
Wrong WEP key entered during the wireless
setup
WEP Key Input Error