Filter
Top Products
Dell™ Printer Configuration Web Tool 109
Security
The Security tab contains the Set Password and IP Filter (IPv4) pages.
Set Password
Purpose:
To set or change the password that is required to access the setup parameters of the printer from the Dell Printer
Configuration Web Tool.
This page can also be displayed by clicking Set Password in the left frame.
NOTE: If you forgot your password, initialize NVM (non-volatile memory) to restore the password to the default (NULL). See
"Reset Print Server" on page 108.
NOTE: When you change the password to lock the operator panel, set the password from Panel Lock Set in the Printer Settings.
Va lue s :
IP Filter (IPv4)
Purpose:
To specify the IP address and subnet mask to be permitted or denied access to the printer.
NOTE: This item is only available for LPD or Port9100.
Va lue s :
Administrator Password Sets the password using up to 10 alphanumeric characters. The password will appear as asterisks
(*) in the field when it is entered.
Re-enter Administrator
Password
Enter the password again to confirm.
Access denial by the
authentication failure of the
Administrator
Sets the maximum number that the administrator fails to log in. If you set 0, this feature is
disabled. The failed attempts counter is reset to 0 by a successful authentication. Every
administrator authentication is rejected if the counter exceeds the maximum number of failed
login attempts.
Address Specifies the IP addresses that are permitted or denied access to the printer. Enter a numeric value
between 0 and 255 in each field.
Address Mask Specifies the subnet mask that are permitted or denied access to the printer. Enter a numeric
value between 0 and 255 in each field.
Active Mode Reject Rejects printing from specified network address.
Permit Permits printing from specified network address.
Disabled Disables the IP Filter feature for the specified IP address.