Filter
Top Products
Installing System Components 117
7
Install the new system battery.
a
Support the battery connector by pressing down firmly on the positive
side of the connector.
b
Hold the battery with the "+" facing up, and slide it under the
securing tabs at the positive side of the connector.
c
Press the battery straight down into the connector until it snaps into
place.
8
Replace the cooling shroud assembly. See "Replacing the Cooling Shroud
Assembly" on page 70.
9
Replace the PEM. See "Replacing the PEM or PEM Shell" on page 76.
10
Close the system. See "Closing the System" on page 66.
11
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
12
Enter the System Setup program to confirm that the battery is operating
properly. See "Using the System Setup Program" on page 43.
13
Enter the correct time and date in the System Setup program's
Time
and
Date
fields.
14
Exit the System Setup program.
15
To test the newly installed battery, turn off the system and disconnect it
from the electrical outlet for at least an hour.
16
After an hour, reconnect the system to its electrical outlet and turn it on.
17
Enter the System Setup program and if the time and date are still
incorrect, see "Getting Help" on page 179 for instructions on obtaining
technical assistance.