Filter
Top Products
Installing System Components 87
NOTE: When future NIC functionality is supported, you must replace the original
TOE/iSCSI hardware key with a new hardware key.
1
Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2
Open the system. See "Opening the System" on page 65.
3
Locate the TOE/iSCSI key connector on the system board (see
Figure 6-1).
If you have an expansion card installed in slot 7, you may have to remove
the card. See "Removing an Expansion Card" on page 80.
4
Insert the TOE/iSCSI key into the connector onto the board. See
Figure 3-16.
Figure 3-16. Installing a TOE/iSCSI Key
5
If applicable, reinstall the expansion card in slot 7. See "Installing an
Expansion Card" on page 78.
6
Close the system. See "Opening the System" on page 65.
7
Reconnect the system to power and restart the system.
1 TOE/iSCSI key 2 TOE/iSCSI key connector
1
2