Filter
Top Products
Installing System Components 123
10
Remove the SAS backplane from the system:
a
If you are removing a 2.5-inch drive backplane,
press the spring-loaded
blue retention tab towards the front of the system, slide the backplane
upward. See Figure 3-30.
If you are removing a 3.5-inch drive backplane,
pull the spring-loaded
blue retention pin away from the front of the backplane, then slide the
backplane upward. See Figure 3-31.
b
When the backplane cannot slide upward any farther, pull the
backplane toward the back of the system to remove it from the
retention hooks.
c
Lift the board out of the system, being careful to avoid damaging
components on the face of the board.
d
Place the SAS backplane face down on a work surface.